Does anyone else have the same problem as me?? I discovered I have way too much costume jewelry!!! I never wear most of it because I can't see it when it is jumbled up in my jewelry box. I came up with an idea to display it forcing me to wear all the pieces. **NOTE** My good jewelry still hangs in my felt lined jewelry box for safe storage.
Black spray paint
Fabric of choice
Hot Glue Gun and sticks
1) I bought cheap frames from Big Lots. I didn't care what color they were, I just bought them for their shapes. 1 was pink, 1 was blue, a couple of gold ones and black too.
2) I broke out all the glass. (do this over the trashcan to avoid a big mess) Make sure to keep the metal clips in place, you will need them later.
3) Spray paint all the frames black, or what ever color is your choice. Let dry.
4) I went to Jo Ann's and bought cork board on a roll. I had a coupon for BOGO, so I purchased 2 rolls. Also purchased the T-pins at the same time.
5) As the paint was drying, I covered the cardboard backing from the pictures with cork. Just cut to size and glue into place.
***TIP*** For the frames that would hold my heavier necklaces, I doubled the cork for more stability.
6) Cover the cork with fabric of your choice. I had leopard on hand, so no expense there, BONUS!! I covered only the front and wrapped the edges by an inch then hot glued the edges down to the cardboard on the back. I ONLY glued down the edges on the front at each corner. I didn't want glue to show through the fabric or get in the way of my pins.
7) Re-insert the fabric covered cork and press the metal clips back into place.
8) I arranged the layout on the floor and then hung into place in my closet. I added a sconce above to finish it off.
9) I then hung my jewelry on T-pins (in the upholstery section at craft stores)
10) VIOLA!!! Homemade jewelry holders!!!
T-pins used for holders
See the missing necklace? Now I know where to hang it when I'm done wearing it!
I chose long frames for bracelets and short necklaces.(hung sideways) Then another one hung the proper way for my longer necklaces.
This whole project took me less than 2 hours start to finish, and less than $30 in supplies. Send me a pic of yours, I'd love to see the finished products. :)
Until the next project!
Tuesday, November 8, 2011
I had this brilliant idea that I was going to make Carson's first Halloween costume. I contemplated over many costumes and nothing seemed to fit his personality...believe me a 6 month old has a personality!! My dad aka JIM PA is always tells Carson pirate stories and is getting him geared up for his 1st trip to Mexico this month. So I thought what a better idea than to make him a pirate with his own personal ship!
The costume was super easy, black pants, a white shirt and a red do-rag. Throw in a foam sword and he was ready to sail the seven seas. Now the harder part comes, how do I turn his stroller into a pirate ship??
First I saved a box from his new walker. I thought it would be big enough, but I had to piece together more cardboard for the front end. I drew out the design on paper and started building!
I cut out the side, even with his stroller so he could see out!
Taped the front end to the sides
The flaps will rest on the tray for stability
The top of the front of the ship, also rests on the tray (see notes later about velcroing these)
see how the 3 wheeled stroller fits right in?? Perfectly!
All finished with the building part. Now to cover the entire thing with brown duct tape to look like wood planks. **NOTE** I wanted the inside of the ship to be "clean" of writing, that is why I did it this way!
I made the cannons out of paper towel rolls. I cut the ends into 4's and then slipped the edges under the tape.
I covered the cannons is a lighter duct tape and then slipped the cut edges under the "planks"
This actually held really well, just place the duct tape around the cannon
3 rolls of dark brown duct tape later, I had the ship finished!! Now just onto the finishing touches!!
I hot glued batting into the cannons for the smoke
See the treasure chest on top?? This was the most time consuming, but I was being meticulous
I bought a paper treasure chest from the party store
I glued yellow felt to the inside as a filler, so I wouldn't have to use as many beads or plastic coins.
Finished treasure chest!!
I cut out a scull from a pirate costume and glued it to the ship. I wanted the treasure chest to be removable for easy transport, so I velcroed it to the ship.
Just when I thought I was finished, I had another idea. The coins need to be spilling out! I hot glued coins to the ship and then set the chest between them. Remember the chest is velcroed for easy removal, so this was a perfect guide as the wear to attach it.
How did I forget the mast??? I rolled 2 wrapping paper rolls in the matching duct tape, and tied them together with some twine. It looked like a cross at Easter draped in material instead of a mast, so I added the guide wires and a parrot.
To attach the ship to the stroller: Remember the flaps from the earlier pics? I attached those flaps to the top of the ship with Velcro and let it sit on the tray. Then in the back, I punched a hole in each side and tied it together with the same twine as the mast.
My happy lil' pirate!!
(see the holes and twine to hold it together??)
Complete with a foam sword!
(I also added another scull to the sail)
3 wheeled stroller turned Pirate ship!!
Carson made a big impression all over town, everywhere he went to trick or treat. Haunt the Zoo, he had hundreds of oohhers and awwers. Celebration Station, he had his picture taken a dozen times. The neighborhoods even loved him. He even made the news!! He was on Channel 4 three different times! And YES, I had them send me a video of it! ;)
I'm not sure if I can outdo myself for his future Halloweens, but he was the best dressed pirate this year.
PS- This folds up flat and is currently in his closet. I'm not willing to sell it (I've been asked), I'm saving it for him to enjoy when he is older!